Which Pace Edwards JackRabbit Aluminum and Vinyl Cover Fits 2002 Toyota Tundra With 8 Foot Bed

Question

Question:

will this fit an 2002 Toyota tundra v6 regular cab, 8ft. bed?

asked by: Joseph

0

Expert Reply:

The # PE94CV is designed as a replacement for Pace Edwards Covers that fit a Ram truck with a 6-1/2' bed. This will not fit your 2002 Toyota Tundra with an 8' bed. For the same style cover that fits the 2002 Toyota Tundra like yours we have the following:

-Pace Edwards JackRabbit Retractable Hard Tonneau Cover # 311-JRT18A32

-Pace Edwards JackRabbit Retractable Hard Tonneau Cover w Explorer Rails # 311-JET18A32

expert reply by: Robin H

0

Answer 1

For your Pace Edwards JackRabbit Retractable Hard Tonneau Cover #311-JRF2903 on your 2007 Ford F-150 6-1/2' bed, you're going to be needing the: -Replacement Tarp for Pace Edwards JackRabbit Hard Tonneau Cover #PE95TJ. Additionally, the…

view full answer...

Answer 2

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 3

Hi Hilario, congrats on the new truck! ^___^ If this were my truck and I was installing a retractable cover on it (which I actually did with my Silverado), I would go with the manual RetraxPRO XR Hard Tonneau Cover - Retractable - Aluminum - Matte…

view full answer...

Answer 4

I spoke with Pace Edwards and they sent me an install instructions sheet for replacing the cover of a Pace Edwards JackRabbit Tonneau Cover. I attached the instructions to this page for you to check out. You do have to rewind the cover's spring…

view full answer...

Answer 5

I spoke to my contact at Pace-Edwards he said that when installing a replacement cover, like the Replacement Cover for Pace Edwards JackRabbit Hard Tonneau Cover #311-TRPT1472-2007, the typical way he recommends to keep the tension on the spring is…

view full answer...

Answer 6

Hey Kurt, I reached out to my contact at Pace Edwards and the Jackrabbit Tonneau Cover TR2003 on your Chevrolet Silverado 2500HD with the 6-1/2' bed requires the replacement cover #PE22KV. The part number you mentioned does not fit your truck.

view full answer...

Answer 7

Hey Ruby, thanks for reaching out! To replace the cover only on your Pace Edwards Switchblade on your 2018 Ford F-150 you need one of the following: - Replacement Fabric Panel with Latch #PE87AJ - Replacement Fabric Panel without #PE27AJ

view full answer...

Answer 8

Hey Rick, no the Replacement Cover for Pace Edwards JackRabbit Hard Tonneau Cover #PE48UV you're looking at is not going to work with your 2014 Ford F-150. Assuming you have a 6 1/2' bed, the correct cover for the Pace Edwards JackRabbit…

view full answer...

Answer 9

Typically if a Pace Edwards Retractable Tonneau Cover like the #311-M-BLFA18A44 is getting hung up it's with the railing and would require lubrication. The canister is a closed system so there isn't a good way to get into it and see if the…

view full answer...

Answer 10

If you had a hard freeze while the cover was wet and it's only had a little bit of time to unfreeze there could still be some ice build up that hasn't fully cleared to allow the locking mechanism to operate. If the truck wasn't sitting…

view full answer...

Which Pace Edwards JackRabbit Aluminum and Vinyl Cover Fits 2002 Toyota Tundra With 8 Foot Bed

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching