Are Load Resistors Included w/ the Behive LED Trailer Tail Light MCL21RB?
Updated 07/21/2022 | Published 07/19/2022
Products Featured in This Question
Question:
2 Diameter beehive. Waterproof, LED trailer light Does this product have a resistor build in? Or should one be installed?
asked by: Charlie
Expert Reply:
The Optronics LED Trailer Clearance or Side Marker Light item # MCL21RB does not include load resistors but we do offer them separately. A load resistor is only needed on the stop/turn circuit which is carried on the yellow wire. Item # DI34ZR is a set of two load resistors that includes quick-splice connectors.
These load resistors will allow your new LED-type trailer turn signal lights to operate without hyperflashing.
Product Page this Question was Asked From
etrailer Rubber Hitch Cover for 2" Trailer Hitches - Qty 1
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- etrailer
more information >
Continue Researching
- Q&A: Will The etrailer Hitch e83ZR Fit A 2026 Subaru Forester Wilderness?
- Q&A: Recommended Flat Towing Parts for a 2026 Ford Maverick Lariat
- Q&A: Stealth Hitch that Fits 2024 Ford Mustang Mach-E
- Q&A: Why Does the etrailer Trailer Hitch part # e72AR Have a Higher Towing Capacity than the Vehicle?
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Will BTBRV Magnetic Hitch Receiver Reducer Sleeve Slide Out While Towing
- Q&A: Will Trailer Hitch From 2014 Toyota RAV4 Fit A 2017 Subaru Crosstrek
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Can I Put Wallpaper in My RV?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today