Furrion Camera System Has No Signal When Connected To Trailer Pre-Wired Hookup

Updated 06/13/2022 | Published 06/11/2022

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen

(736)

$465.79

Hook Probe Circuit Tester

(67)

$14.09

Question:

My rv is previously wired and has a slot for my furrion back up camera . When I pair it in my truck with the camera and screen it works fine but when I installed it in the rear of the trailer I plug it in the camera light doesnt come on and the monitor says no signal

asked by: Joe

Expert Reply:

Since you're getting a "No Signal" error or your Furrion Vision S Wireless RV Backup Camera System w/ Night Vision # FOS43TASF, that is an indication that there is an interruption in the power wire.

I recommend using a circuit tester like # PTW2993 to verify that you're getting 12v power to your camera. Usually these pre-wired hookups are wired to your trailer's reverse lights so the camera will come on when reversing and act as a reverse camera.

You'll also want to make sure that your truck's headlights are on, and that the camera is not being obstructed by any large objects as this could have an impact as well.

expert reply by: Bryce D