Scissor Step for Trailer with 24 inches of Height and Lower Rise Between Steps
Published 04/29/2022
Question:
If it is not fully extended will it cause the steps to overlap?
asked by: D D
0
Expert Reply:
I wish we had something as we get this request a lot but all of the scissor step kits out there like the Brophy Scissor Steps part # AS03 have a higher amount of rise between the steps at around 8 inches like this one. Now with that said since this step set has a range of 24 inch to 30 inch and your height is 24 inches there's a good chance this would actually have a slightly lower rise between steps.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy Camper Scissor Steps - 3 Steps - Aluminum - Diamond Tread - 17" Wide - 250 lbs
- RV Steps
- Truck Camper
- Snap-On Step
- 17 Inch Wide Step
- 18-1/4 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- 24 Inch Entry
- 25 Inch Entry
- 26 Inch Entry
- 27 Inch Entry
- 28 Inch Entry
- 29 Inch Entry
- 30 Inch Entry
- Aluminum
- Brophy
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: I Just Replaced My SEAFLO Pump So Do I Need to Recheck the Accumulator Pressure?
- Q&A: Fitment of Brophy Camper Scissor Steps for Truck Campers
- Q&A: TorkLift Tie Downs for 2018 Ram 2500 With No Running Boards
- Q&A: Is It Optional To Install The Adapter Base Plate With The Camco RV Heating Wall Thermostat?
- Q&A: How to Install a Tailgate Adapter for use With Brophy Scissor Steps
- Q&A: Does Torklift Tie Down # TLD3109 Fit 2015 Ram 2500
- Q&A: Recommended Bed Tie Downs and Turnbuckles for a 2015 Ram 2500
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Mount a Truck Bed Camper
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
D D.
4/29/2022
If it is not fully extended will it cause the steps to overlap?