Replacement Landing Gear Foot Pads for Lippert Ground Control 3.0 System
Published 04/22/2022
Products Featured in This Question
Question:
I have a 2017 grand design relection with the Lippert 3.0 landing gear. Square ram in front and round ram in rear. I want to replace pads with your lippert landing gear pads LC314667. Will this pad fit both front and back rams?
asked by: Michael T
0
Expert Reply:
Lippert offers a replacement foot pad for the 3.0 Ground Control kits with the part # LC377962 for the rear and part # LC362486 for the front. These are both 9 inch diameter plates like what you referenced. The part number you mentioned does not fit the Ground Control though.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert 5th Wheel RV Landing Gear Foot Pad - 9" Round
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- Lippert
more information >
Continue Researching
- Q&A: Will Utopia Pop-Up Drain Fit a Smaller Sink Opening?
- Q&A: 90 Degree Angled SmartPlug Connector For Inlet
- Q&A: Recommended Landing Gear Foot Plate for 9 Inch Round Upgrade on 2016 Flagstaff Super Lite 5th Wheel
- Q&A: Bike Rack Recommendation for NuCamp 320 Camper
- Q&A: Troubleshooting Flashing Error Code 5.H on Tekonsha Prodigy Brake Controller
- Q&A: What's the RV Designer Motorhome Entrance Door Lock w/ Deadbolt RD68SR Made of?
- Q&A: Solution for Replacement Foot Plate for Lippert Level Up System
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Best Air Bag Suspension 2025
- Article: 5 Products You Need For Your Next Camping Trip (2022)
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?