Will Low Profile LED Flood Light # OPT64FR Light Up Ramp/Door

Question

Question:

OPT64FR Flood Light. If I mount one of these in the center above door/ramp in closed position on 8.5 ft wide car trailer will it light up the entire width of the door/ramp when in the down/ loading position?

asked by: DONALD

0

Expert Reply:

Yes, since the Low Profile LED Flood Light # OPT64FR puts out 1,000 lumens it would easily light up a door/ramp like you mentioned.

expert reply by: Jameson C

0

Answer 1

The Low Profile LED Flood Light #OPT64FR does not come with mounting hardware. However, the holes are about 5/16 of an inch in diameter and the distance between the mounting holes are 3-3/4 inches apart. I went ahead and linked a video to some more…

view full answer...

Answer 2

The Low Profile LED Flood Light #OPT64FR is rated IP X7. This means the device has level 7 water sealing, while its protection against dust is unknown.

view full answer...

Answer 3

I recommend mounting the Low Profile LED Flood Light #OPT64FR on the upper frame of your trailer. This light is 2" tall and will broadcast the light down at a 45 degree angle. The housings are made of aluminum to help protect the light from…

view full answer...

Answer 4

The color of the light that the Low Profile LED Flood Light part #OPT64FR puts out is a bluish white which is very common for LEDs. For a warmer light that would work great the Omega LED RV Porch Light part #328-007-30SCPE which puts out a warmer…

view full answer...

Answer 5

There really isn't going to be a "typical" size for an oval exterior light, but if your light is overall 4.33" long and has 3.75" between the mounting holes then this light will work for you.

view full answer...

Answer 6

It sounds like you're needing a light like the Great White LED Trailer Back Up Light #PE44AR. This has a 7" diameter and a simple 2-wire connection. Since it's a surface mount light you only need to make a small hole for the wiring…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Will Low Profile LED Flood Light # OPT64FR Light Up Ramp/Door

Product Page this Question was Asked From

Continue Researching