How Does Taillight Ring # A78RXB Get Removed
Published 04/05/2022
Products Featured in This Question
Question:
Whats the best way to remove the tail light reflective ring so as to not break of any of the 4 clips that hold it in place? Thx
asked by: Bruce H
Expert Reply:
To remove the ring # A78RXB you basically would want to grab one side of the ring and gently pry up on the ring till it releases from the mounting flange. If it does not want to remove this way you can use a thin slot screwdriver and slide it down into the slots on the sides of the light. This will allow you to push on the hooks of the ring so that they will release from the light. See picture to see where to insert the screwdriver.
(click to enlarge)
Product Page this Question was Asked From
Optronics LED Trailer Light w/ Flange - Brake, Turn, Tail - Submersible - Surface Mount - Oval - Red
- Trailer Lights
- Tail Lights
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 7-9/16L x 3-5/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Wheels And Hubs For A Triton LTWCI Personal Watercraft Trailer
- Q&A: Determining Which Taillights Fit Skeeter Boat Trailer
- Q&A: Diameter of Mounting Bracket Hole on Round Snap Ring Swivel Jack
- Q&A: What Comes Included With The Timbren Silent Ride Suspension for Tandem Axles TSR7000T04?
- Q&A: Best Location to Weld Ultra-Fab Steel Micro-Roller Skid Wheels # UF48-979021 on 5th Wheel Trailer
- Q&A: Rear SumoSprings for 2021 Nexus Rebel 30R
- Q&A: Replacement for Lippert Slide Out Motor 131903
- Article: Trailer Lighting Requirements
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Double-Eye Trailer Suspension System Review