Troubleshooting Phoenix Electric Trailer Jack for Beeping
Published 04/05/2022
Question:
I have a Phoenix 5500. When I try to raise or lower it it beeps one time when I push the button and nothing happens. Im pretty frustrated at this point.
asked by: Micah T
0
Expert Reply:
When we have seen this before with the Phoenix Electric Trailer Jack, # UF38-944040 it frequently is from an improper voltage reading. The unit is shutting itself off for protection. Please verify that your battery bank is fully charged and in good working order then check all the wiring connections for the jack ensuring you have a good ground.
expert reply by:
Michael R
0
Product Page this Question was Asked From
Phoenix Electric Trailer Jack - A-Frame - 18" Lift - 4,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- With Round Foot
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Do I Have to Wire the Phoenix Electric Trailer Jack UF38-944040 Directly to the Battery?
- Q&A: Troubleshooting Phoenix Electric Trailer Jack UF38-944040 Beeps And Will Not Go Down
- Q&A: Availability of 5k Electric Jack That Turns 90º
- Q&A: Recommended Electric A-Frame Jack w/a Tongue Weight Scale
- Q&A: What is the Quickest Electric Jack for a A-Frame Trailer?
- Q&A: Electric Tongue Jack for 7,000 lb Cargo Trailer
- Q&A: Troubleshooting Phoenix 4000 Electric Jack Not Working
- Article: The Best Electric Trailer Jacks of 2025
- Article: How to Install an Electric Trailer Jack
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Trailer Wiring Diagrams
- Article: Big Truck Big RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Performance Chips and Modules