Recommended Voyager Camera for Pre-Wired 2021 Winnie Minnie  

Your 2021 Micro Minnie is wired for the Voyager observation camera setup which means the correct kit is the part #ASA37YR. The #ASA37YR was specifically designed for trailers that were pre-wired for the Voyager setups.

We do have what you need, but since your 2022 Winnebago 2529RG is prewired for the Voyager system you will not want to use the Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision #ASA57YR that you were looking at. Because you will…

There isn't an adapter to connect the wiring of a Furrion camera to a Voyager. With that said you can pretty easily just cut the connectors off and then connect to the camera since it's only two wires.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Michael, thanks for reaching out! The EcoHitch #EH57FR sits a little higher than the Curt #C52NR so it will give you better ground clearance for your 2024 Chevy Silverado 2500. The EcoHitch is a bit more recessed into the front bumper than the…

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt pattern…

Yes Todd, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL67PD will fit your 2023 Ford F-150 Tremor. These air bags have 5,000 lbs of load leveling capacity, an adjustable air pressure range of 5 to 100 PSI,…

The main difference between the Timbren Suspension Enhancement System #TFRTT1504E and the Timbren Rear Suspension Enhancement System #TFR1504E on your 2022 Ford F-150 is going to be the weight capacity and purpose the system is intended for. The…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Thanks for the kind words! Yes, the Custom Fit Tie Down Kit item #TL82FV does include both Front item #TLF2018 and Rear item #TLF3007 tie downs. These fit the 2018 Ford F-150 with a 6-1/2' bed.

Hello Sean, for your 2024 F150 you can indeed use the etrailer Invisible Base Plate Kit - Removable Arms #e86YR. This is compatible with all etrailer and demco tow bars, and an adapter allows it to be compatible with others. I recommend sticking to…