Replacement Lift Motor for Maxx Fan

Question

Question:

When you close the vent with the remote after it closes completely it continues to keep trying to close. If the house batteries are off and you turn them on it send power to the vent and try to close again even if it already closed, this will last for a few second. what part on this unit controls the open and close position sensing for the unit

asked by: Charles H

0

Expert Reply:

The Replacement Lift Motor for Maxx Fan, # MA10-20270 works with models 00-4501K, MA00-04500K, MA00-07000K, or MA00-07500K. If you have a different model fan, ,please let us know.

expert reply by: Michael R

0

Answer 1

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 2

Unfortunately, the Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Reversible Fan #MA10A21275K you ordered would not be the correct circuit board. The correct circuit board is the Replacement Printed Circuit Board for…

view full answer...

Answer 3

Your MaxxFan Plus Roof Vent #MA00-04500K uses the Remote #MA00A01150K. The Key Wall Control #MA00A03550K is not compatible with your fan.

view full answer...

Answer 4

If your MaxxFan Plus Roof Vent #MA00-04000K isn't responding at all to the remote then most likely it just needs to be replaced with part #MA00A01150K or the batteries are just in need of a change. I do also recommend verifying that you're…

view full answer...

Answer 5

Since multiple MaxxAir Fans have the same features that you listed it's honestly best to first determine the exact model number you have before purchasing anything and end up not having it be compatible. I've listed below all the available…

view full answer...

Answer 6

Sounds like the remote is down for the count and needs to be replaced. If you have the MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke #MA00-07500K you will need the Replacement Handheld Remote for…

view full answer...

Answer 7

You reported that you cannot use the remote on your MaxxFan 4700K to put the vent cover up and down. Let's troubleshoot. Put some new batteries in your remote. Ensure that the display comes on. Verify if your vent cover now works. Verify if other…

view full answer...

Answer 8

The Maxxair website doesn't list the 4900K as coming with a remote control option. It may have been something added by a manufacturer. The Replacement Handheld Remote for Maxxair Roof Vent Intake/Exhaust Fans - Qty 1 #MA00A01150K or the Exhaust…

view full answer...

Answer 9

It sounds like a circuit board issue. I recommend the Replacement Printed Circuit Board for MaxxAir Manual Lift RV Roof Vents #MA10A21275K if you have a 4500K, 7000K, or 7500K model. If your model is a 4000K, 5100K, or 6200K then Replacement Printed…

view full answer...

Answer 10

The Replacement Handheld Remote for Maxxair Roof Vent Intake/Exhaust Fans - Qty 1 #MA00A01150K is what you need for compatibility with your 5100K model. This will allow you to control the vent from the front seat. This is a remote control and we do…

view full answer...

Answer 11

Most likely the circuit board for your MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-07500K is faulty and needs to be replaced, but there are a few things we can check first before replacing it with part #MA10A21275K. A lot of the time there could be a…

view full answer...

Answer 12

If you have tested the RV's power and ground wires leading to your MaxxFan Trailer Roof Vent #MA00-04000K and you have a full 12V of power reaching the vent's fan motor then there might be damage to the unit's control circuitry or the…

view full answer...

Replacement Lift Motor for Maxx Fan

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching