Troubleshooting Solera Slide Out Hall Sig Not Present
Published 02/15/2022
Question:
i have 3 slide 5th wheel , big living slide came in fine, big dining room slide came in fine. bed room slide only wants to work on one side going in and out, its like right side of slide hugh up , nothing blocking it. code on 13398-c2 says hall sig not present, need your help on hall sig not present.
asked by: Bertram G
0
Expert Reply:
The hall sig not present according to Lippert means the encoder is not providing a signal which typically is a wiring problem so you'd have to just go over the wiring looking for any obvious shorts to clean up.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Replacement Controller for In-Wall Slide-Out - V-Sync II
- RV Slide Out Parts
- Controller Parts
- Controller
- Lippert In-Wall RV Slide-Out Systems
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How Does The Cummins Onan P11000iTF Paralleling Kit Work?
- Q&A: Troubleshooting Dual Motor Slide Out Malfunctions
- Q&A: Does Lippert Slide Out Controller 13398-D0 Have Lights On It
- Q&A: Replacement Slide Controller For 13398-C Dual Motor Synchronous Velocity Slide Controller
- Q&A: Parts Needed for Installation of Onan Generator QG 7000i
- Q&A: Dometic Soft Start for Dometic B59516.711C0-MX
- Q&A: Will Soft Start Kit for Coleman-Mach RV Air Conditioners Fit Mach 15 38009-0650 and 38209-0650
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Must-Have Flat Towing Components
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Frequently Asked Questions About Transmission Coolers
- Article: Curt Echo Full Review
- Article: Troubleshooting Brake Controller Installations