The Replacement Round Bar Head 58112 will Accommodate a Hitch Ball with a 1-1/4 Shank
Published 01/21/2009
Question:
What size ball shank does part take?
asked by: W W
0
Expert Reply:
The weight distribution heads will always have a 1-1/4 inch hole for the ball shank. Therefore, the replacement round bar head, part # RP58112, will accommodate a hitch ball with a 1-1/4 inch shank.
expert reply by:
Andi
0
Product Page this Question was Asked From
Replacement Head for Reese Weight Distribution System - Round Bar
- Accessories and Parts
- Weight Distribution Hitch
- Head
- Round Bar
- Reese
more information >
Continue Researching
- Q&A: Replacement Head for Reese Weight Distribution # 61241
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Weight Distribution System Needed for a Trailer with a Tongue Weight of 2,300 lbs.
- Q&A: Replacement Head and Shank for a Weight Distribution System
- Q&A: Recommended Friction Sway Control System For Dual Friction Setup
- Q&A: Replacement Hitch Head for Reese Straight-Line 17K Weight Distribution System
- Q&A: Recommendation for Adding 2nd Friction Sway Control Bar to Trailer
- Q&A: Is Replacing the Head of a Weight Distribution System Difficult
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Choose the Right Trailer Hitch Class
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft