Recommended Hardware to Install Plunger and Socket Trailer Door Holder
Published 12/14/2021
Products Featured in This Question
Question:
What hardware should I use with this?
asked by: Arthur V
0
Expert Reply:
According to the manufacturer you need 1/4 self tapping screws to install part # PLR64-66.
Most likely you'll just find them at your local hardware store. We have part # FA1131822 which are 1-1/4 inches long.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 2-1/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- Straight
- 2-1/4 Inch Long
- 2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Q&A: Recommended Soft Start for a Furrion AC Unit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: What is The Proper Way To Measure A Trailer Fender?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: Longest Available Door Replacement Plunger
- Q&A: Replacement Plunger Door Holder Socket for a Polar 68 Socket
- Q&A: When do You Need a Breakaway Battery Charger and How Does it Function
- Q&A: Replacement Inner Tube For Gooseneck Trailer Coupler That Doesnt Use Through Pin
- Q&A: What Inner Tube do You Have for My Bulldog Gooseneck Coupler that Doesn't Use Load-Bearing Pin?
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Replace an RV Roof Vent Cover
- Article: Roof Rack Information