Brake Assembly Option for 7200 lb Rated Axle

Question

Question:

These are the brakes I have on my 5th wheel DEXTER K23-429-00 – ELECTRIC BRAKE 12.25? X 2.5? just wondering if there is a cheaper option

asked by: Luis C

0

Expert Reply:

Unfortunately, due to the unique pad size and brake assembly mounting bolt pattern used by a 7200 lb rated axle, the Dexter # 23-429 (right side) and # 23-428 (left side) are the least expensive (and the only) replacement brake assemblies we offer for your particular axle.

expert reply by: Mike L

0

Answer 1

Yes we do, the correct oil seal you would need is the part #10-56 which I verified has same dimensions as the 295924 that you have now.

view full answer...

Answer 2

It sounds like you may have a short in the wiring on your 2022 Ford F-350. You can use a Multimeter #PT29ZR to check this at your 7-way by checking for continuity with the brake wire and any other wire on the 7-way. You can see the terminals in the…

view full answer...

Answer 3

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 4

Hello Gregory. Uneven tire wear is often a sign of a bent axle or spindle. If you want to check this by yourself the best way is to first make sure the trailer is on perfectly level ground. You will then take a measurement from the ground to the end…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Dave, for a saltwater boat trailer, powder-coated wheels wouldn't be my first choice, but they can still last quite a while if you're good about rinsing them thoroughly after each launch and sealing any chips or cracks in the finish as…

view full answer...

Answer 11

Hey, Lance. The direction the springs are in doesn't matter. They can be to the front or to the rear of the axle and will perform the same either way. What kind of trailer are you working on?

view full answer...

Brake Assembly Option for 7200 lb Rated Axle

Products Featured in This Question

Continue Researching