How Do I Tie In My Reverse Lights To A 7-Way Connector On My 2021 Volvo XC90
Updated 11/19/2021 | Published 11/12/2021
Products Featured in This Question
Question:
I watched a video on this site that showed how to set up a 7 pin plug using 118683 and ETBC7 on a 2018 XC90, but near the end of the video I noticed that the reverse lights were not tied in. Do you have insight on how reverse lights are to be tied into the 7 pin plug? DO I need any additional parts?
asked by: Dan M
Expert Reply:
Most trailers do not utilize the reverse circuit. In this instance we did not hook up the reverse lights to the 7-way connector. You can easily tie the reverse lights into your 7-way connector. the yellow wire on the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires, part # ETBC7, will get tied into the reverse circuit on your vehicle. You will need to splice the reverse wire to tie the wires together.
I have included a helpful link about wiring a 7-way connector to your vehicle below.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 900 lbs TW
- 6000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Much Does Adding Curt Trailer Hitch Reduce Ground Clearance on a 2016 Volvo XC90
- Q&A: Which Hitch is Better for a 2024 Volvo XC90 Recharge? Oris or the Stealth Hitch?
- Q&A: Trunk Mounted Bike Rack Compatible with 2016 Volvo XC90 Spoiler
- Q&A: Does the Oris AK41 Hitch Block the Foot Sensor on a 2021 Volvo XC90?
- Q&A: Is the Oris Hitch a Comparable and More Affordable Option to the Stealth Hitch on a 2026 Volvo XC60?
- Q&A: Will Stealth Hitch Fit 2025.5 Volvo XC90 PHEV
- Q&A: Best Hitch and Trailer Wiring for 2021 Volvo XC90
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Rooftop Cargo Carriers
- Article: Dealer Spotlight - Croft Trailer and Hitches
- Article: Trailer Wiring Diagrams
- Article: Best Hitch Cargo Carriers
- Article: Which Hitches are Made in the USA
- Article: My Trailer Hitch Doesn't Fit
Mark S.
11/19/2021
Most trailers do not utilize the reverse circuit. In this instance we did not hook up the reverse lights to the 7-way connector. You can easily tie the reverse lights into your 7-way connector. the yellow wire on the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires, part # ETBC7, will get tied into the reverse circuit on your vehicle. You will need to splice the reverse wire to tie the wires together. I have included a helpful link about wiring a 7-way connector to your vehicle below.