Fan-Tastic Vent Roof Vent 7350 Motor Runs Continuously After Lid Is Shut

Question

Question:

when lid is shut motor to shut lid comes on to shut lid then stops again and again have to pull fuse to stop

asked by: Manny

0

Expert Reply:

For your Fan-Tastic Vent Roof Vent # FV807350 I suggest you check your roof vent plunger switch and ensure it is working properly and isn't rusted or corroded. This switch could be the source of your issue causing your motor to run until the fuse is pulled.

Alternatively, you could also replace the fan and motor with # FVK8017-00 if that does not solve the issue, this will fit fan models: # FV800800, # FV801200, # FV801250, # FV802250, # FV803350, or # FV807350.

expert reply by: Bryce D

0

Answer 1

For most golf carts you want to go with a 1,000 lb capacity loading ramp. I would however recommend the Erickson Arched Ramps part #EM07486 as they have a 3,000 lb capacity, an aluminum construction which will make them lightweight, and straps that…

view full answer...

Answer 2

Hey Randy, It is definitely possible that with the replacement of the lift motor to part #FVK6010-80 that it wasn't tightened up exactly the same as the previous motor, causing the gears to not engage. You'd have to take a look at the…

view full answer...

Answer 3

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Hey John! The toilet you have now is the Dometic SeaLand 111, and the Dometic 411 RV Toilet #DMC74JF will be a great replacement for it. The 411 is specifically designed as a low-profile toilet for RVs with a raised toilet platform. It measures…

view full answer...

Fan-Tastic Vent Roof Vent 7350 Motor Runs Continuously After Lid Is Shut

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching