Troubleshooting No Cruise Control of 2008 Honda Element after Trailer Wiring Install
Published 10/18/2021
Question:
Hello I installed this trailer wiring harness yesterday and now my cruise control wont work. Any suggestions on what went wrong? Thanks.
asked by: Chris
0
Expert Reply:
First try removing the harness to see if the cruise control starts to work again. That will isolate the harness or the install as the problem. Next try carefully reinstalling it and see if the problem comes back. Sometimes a connector not seating all the way or a fuse not install properly causes odd issues. If that does not fix it the harness is most likely bad and would need to be replaced.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: How Are the Bearings in the Malone LowMax Trailer Greased and Re-Packed
- Q&A: Kayak Carrier for Old Town Predator 13 on Honda Element
- Q&A: Replacement Mounting Hardware for an OEM Hitch on a 2008 Honda Element
- Q&A: Hitch Recommendation for a 2010 Honda Element
- Q&A: Replacement Parts for Suburban Model SW6 DE Water Heater
- Q&A: Is there a Plug In Wiring Harness for the 2005 Honda Element
- Q&A: How Do I Know How High The Ball Should Sit Above the Ground
- Article: How to Choose the Right Trailer Hitch Class
- Article: Where to Position the Trailer Axle?
- Article: Rooftop Cargo Carriers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Curt Echo Full Review
- Article: Diode Installation Instructions for Dinghy with Combined Tail Light Wiring