Stromberg Carlson Landing Gear Clicks And Does Not Lift

Updated 09/09/2021 | Published 09/08/2021

Products Featured in This Question

Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs

(39)

$233.77

NOCO NCP2 Battery Terminal Treatment Kit w/ Terminal Protectors and Preventative Spray

(1)

$9.55

Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor

(35)

$570.38

Digital Multimeter with 42" Long Test Leads - LED Display

(3)

$21.87

Question:

landing gear motor kicks real loud and doesnt lift

asked by: Marcus

Expert Reply:

Typically this is attributed to a weak battery or a weak ground connection. Start by checking your grounds and ensuring they are tight and on a good, clean, bare metal location. Additionally, check your battery terminals and make sure they are tightened and are not corroded. Finally, check the charge of your battery with # PT89ZR and ensure it reads 12.6 volts or higher.

If you find your battery terminals are corroded or rusted, you can use the NOCO NCP2 Battery Terminal Treatment Kit w/ Terminal Protectors and Preventative Spray # 329-MC101 which includes 2 terminal pads and 1 NCP2 spray bottle to ensure complete protection. This will ensure your battery stays clean from corrosion and rust so you always have a solid connection.

If it turns out not to be the battery connections or your ground connections, it may be a bad motor, in that case you will need to replace your motor with # LC196308. However, you should start by checking your electrical connections first.

expert reply by: Bryce D