Will Drilling Be Required to Install Lippert Scissor Stabilizer Jacks
Updated 08/27/2021 | Published 08/26/2021
Question:
Hi, I puechased a Lippert stabilizer jack and none of the holes lined up across all foue holes. Is it possible to order/attach other mounting brackets if the screws attaching it to the jack fit?
asked by: Kevin S
Expert Reply:
The Lippert Scissor Stabilizer Jacks # LC285325 mounting plate is designed to be a universal fit that will match most scissor jacks installed at the factory, but it's not necessarily always going to be a perfect match. Unfortunately there is not a mounting bracket available for these jacks and in the event that the holes don't match up to your existing holes you'll need to drill new holes in the trailer frame to match the stabilizers.
Product Page this Question was Asked From
Lippert Scissor Stabilizer Jack - 24" Lift - 5,000 lbs - Qty 1
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 24 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Continue Researching
- Q&A: Will Lippert Scissor Jack # LC285325 Fit Tristar 5000
- Q&A: Scissor Stabilizer Jack Base Hole Spacing Dimensions
- Q&A: Recommended Installation Hardware for etrailer Scissor Stabilizer Jacks e36VV
- Q&A: Can the Lippert Scissor Stabilizer Jacks # LC285326 be Installed on a 26 foot Motorhome
- Q&A: Can You Replace the Threaded Rod in the RV Scissor Jacks
- Q&A: Soft Start for Grand Design Reflection 297RSTS With Coleman-Mach 48204-669
- Q&A: Troubleshooting Installation of B&W Companion 5th Wheel Hitch in 2001 GMC 2500
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?