Can the Bushing Inside the Convert-A-Ball Ball Mounts Be Replaced
Published 07/15/2021
Question:
Do you offer a rebuild kit to replace the polyurethane bushings inside this hitch?
asked by: John
0
Expert Reply:
The bushing inside the Convert-A-Ball Ball Mounts like part # AMSC2 is not replaceable. Therefore, if the bushing is worn or damaged the entire ball mount will need to be replaced unfortunately.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Convert-A-Ball Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Shock Absorbing
- Convert-A-Ball
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended Hitch Extender for Towing with a 2008 Range Rover
- Q&A: Can A Convert-A-Ball Cushioned Ball Mount Be Used With A Curt RockerBall?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: USA Made 2 inch Trailer Hitch Balls
- Q&A: Picture of Gorilla-Lift Utility Trailer Tailgate Lift Assist Installed on Bifold Ramp Trailer
- Q&A: LED Replacement Trailer Taillights for Peterson 440-15R
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Determining Trailer Tongue Weight
- Article: Rust Prevention