Is Curt Trailer Hitch C11390 For 2012 Ford Fusion Limited To Class I Accessories?

Updated 07/13/2021 | Published 07/12/2021

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(20)

$231.38

1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs

(362)

$35.58

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(362)

$40.41

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2327)

$51.26

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2977)

$3.71

Question:

Is the tab welded on the Curt hitch for class one asscessories only

asked by: Ken G

Expert Reply:

The Curt Trailer Hitch Receiver # C11390 you were looking at for your 2012 Ford Fusion does have a welded tab limiting you to Class I compatible accessories, so you will need to double check that the accessories you purchase are compatible with Class I hitches.

This is done to make sure the accessories you use will not allow you to overload the hitch.

If you are planning on doing some light duty towing with your Fusion you will need a vehicle wiring harness # 118422, drawbar # C45521, 1-7/8" hitch ball # A-80 or 2" hitch ball # A-82, and hitch pin and clip # F-4.

I included a few videos of the products mentioned for you to take a look at.