Propane Hose With Back Check Valve

Question

Question:

Does this propane hose include the spring and ball that make up the back check valve? I did not see it in the pictures.

asked by: Monte H

0

Expert Reply:

The back check valve is inside of the Type-1 Male end piece on your MB Sturgis Propane Hose Assembly - RV Type 1 w/ Back Check x 1/4" MPT - 12" Item # 100473-12.

expert reply by: Kevin C

0

Answer 1

Yes, the MB Sturgis Propane Hose w/ Back Check part #100473-30-MBS would replace the leader hoses on your trailer that lead from the propane tanks to the propane regulator. All of the leader hoses have back check valves. If you would like to upgrade…

view full answer...

Answer 2

In order to correctly measure a propane hose you will need to measure end to end (fitting to fitting). The propane hoses we sell are by the foot so this may make it easier to determine what you need. It is also a good idea to get a hose that is a bit…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

You sure can Jim! You can definitely rewire the AC input to the WFCO Auto Detect RV Converter and AC/DC Distribution Panel item #WF86FR to isolate it from your inverter by installing an automatic transfer switch. For a 3,000 watt inverter, I…

view full answer...

Answer 5

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

view full answer...

Answer 6

I attached a picture that shows what the typical dual tank setup looks like with the accessories needed labeled. First thing you need is pig tails to go from the tanks to the regulator like the part #100473-12. Then for a dual tank regulator with…

view full answer...

Answer 7

We offer the necessary replacement pigtails in many lengths for rubber hose, you can use #37207-30755 for a 2 foot length, #37207-30775 for a 3 foot length or #CAM59183 for a 4 foot length. If you'd prefer braided steel hose for durability, use…

view full answer...

Answer 8

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 9

Hey, Corde. The type of hose you are looking for comes with either a 1/4 Inch male NPT or the 1/4 Inch MIF. Since you're not needing the MIF you would want to pick up MB Sturgis propane pigtail part #100473-12. This one is a 12" hose so if…

view full answer...

Answer 10

Hello Howard, Thanks for writing in! I'm glad you found us, again =) Yes, the Draw-Tite ball mount #2923 will fit your 2024 Tesla Model Y with the factory towing package since it uses a standard 2-inch hitch receiver. The main thing to verify is…

view full answer...

Propane Hose With Back Check Valve

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching