Bolt Hole Dimensions for Mounting Cargo Smart Anti-Rattle Tie Down

Question

Question:

I am looking to use a square u bolt to hold this down. What is the diameter of the bolt hole? Or, do you sell a square u bolt that will fit the mounting bracket?

asked by: Matt J

0

Expert Reply:

The CargoSmart Anti-Rattle D-Ring Tie-Down Anchor # 3486553 will require 1/4" mounting hardware. The center hole measurements for the bolt holes are 1-3/8" apart.

At this time we will not have any square u-bolts that will fit the anchor.

expert reply by: Bud M

0

Answer 1

The CE Smith Carpeted Bunk Boards #CE27800 are made from untreated southern yellow pine which is a wood that can withstand a high amount of moisture without rotting. Then they are covered with a marine-grade, weather resistant black carpeting

view full answer...

Answer 2

The Trailer D-Ring Tie Down item #LRB1, will accept bolts no larger than 7/16 inches in diameter so you could go with a 3/8 inch bolt/nut or screw. For your application you can use standard hardware from your local hardware store. I recommend using…

view full answer...

Answer 3

The actual puck itself is a standardized size between each brand so the only measurement that matters is the spacing of the pucks, which differs between each vehicle manufacturer. I've attached a diagram below with the spacings used by…

view full answer...

Answer 4

The Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit #SH25VR we have is going to come with a passive harness. Since your 2019 BMW X5 xDrive40i has the 8SL towing option you would need to just order the Rack #SH89VR from us and the Active…

view full answer...

Answer 5

I was able to verify with Detail K2 the 2.047" hub bore size is what they currently use on their trailers. They did mention you could have a different size depending on the age of the trailer as they did not always use the same size hubs. Since…

view full answer...

Answer 6

The good solution would be the Pace Edwards #311-SWFA07A30 "Switchblade" retractable hard tonneau cover. This specific cover is designed for a Ford F-150 truck with an 8-foot bed. Since this system has it's own track you will only need…

view full answer...

Answer 7

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 8

I have attached some diagrams of the wiring for the Lippert Replacement Hydraulic Power Unit with 2-Quart Pump Reservoir Kit for RV Slide-Out IRC System #LC141111. The first one is from my contact at Lippert and some of the extra wiring is from their…

view full answer...

Bolt Hole Dimensions for Mounting Cargo Smart Anti-Rattle Tie Down

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching