Where Does Replacement Spring part # CA-5196-SPR Install on Coupler
Published 08/08/2016
Products Featured in This Question
Question:
Is this the spring that pushes the collar/sleeve forward or the one that pushes the wedge out to lock the coupler open?
asked by: Jeff
0
Expert Reply:
The spring part # CA-5196-SPR that you referenced is the spring of the coupler like part # CTA-196 that pushes the parts of the coupler apart when the sleeve is pulled back.
I attached a picture that shows a very similar Bulldog coupler. You can see the spring in the picture. The referenced spring is the same application as what you can see in the picture.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Replacement Spring for Ram Sleeve Lock Couplers - 7,000 lbs and 12,500 lbs
- Accessories and Parts
- A-Frame Trailer Coupler
- Adjustable Trailer Coupler
- Springs
- etrailer
more information >
Continue Researching
- Search Results: trailer gps tracker
- Search Results: spare tire locks
- Search Results: pin locks
- Search Results: d ring
- Shop: etrailer Anti-Rattle Hitch Collar for 2.5" Hitch Receivers
- Q&A: How Long Is Battery Life On PingMaster Trailer Tracker Device?
- Shop: Trailer Valet Round Pipe Mount Swivel Jack w/ Footplate - Sidewind - 10" Lift - 3,000 lbs
- Video: Stop Trailer Theft Now | Pingmaster Insider Insights
- Shop: etrailer Forged Steel D-Ring Tie-Down Anchor with Bolt-On Clip - 1/2" - 4,000 lb WLL
- Shop: Replacement Spring for Ram Sleeve Lock Couplers - 7,000 lbs and 12,500 lbs
- Shop: TowSmart Locking Boomerang Hitch Pin and Coupler Lock - 1-1/4" and 2" Diameter
- Shop: etrailer Spare Tire Lock for 1/4" to 7/8" Thick Rims - Keyed Alike
- Shop: 2-1/2" Long Torx Floor Screws, 40/Pkg
- Video: Comprehensive Review: Trimax Trailer Wheel Chock and Lock
- Video: Ultimate Overview of the Replacement Spring for Ram Sleeve Lock Couplers
- Search Results: 3500 lb axle bearings
- Article: Most Popular Wheel Bearings
- Video: Hands-On with the Sleeve-Lock A-Frame Trailer Coupler
- Shop: Suspension Enhancement
- Q&A: Dimensions of Replacement Spring for Ram Sleeve Lock Couplers
- Search Results: boat trailer brackets
- Search Results: trailer winch
- Q&A: Bolt Hole and Bracket Spacing for the etrailer Sleeve-Lock Trailer Coupler
- Q&A: How To Tell If Ram Replacement Spring CA-5196-SPR Would Fit Bulldog 2-5/16" Coupler
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Replacement Coupler Cap Spring for Hammerblow Collar-Lok Coupler
- Q&A: Replacement Spring for Buldog Collar-Lok Coupler
- Q&A: Skid Wheel Needed for Coupler with Safety Chains Loops in the Way of Hitch Pin Mounted Wheel