Replacement Foot Pad for Lippert Ground Control 3.0

Question

Question:

2021 Outdoors RV Glacier Peak 5th wheel, 26RKS model. Has the Lippert 3.0 ground control auto leveling 4 point system. The bottom foot pad is bent and want to replace it. The pad is attached to the leg and this looks like it, but want to check as this references a front jack use. Thank you.

asked by: Paul C

0

Expert Reply:

The replacement foot for the rear Lippert jack on the Lippert Ground Control 3.0 System is # LC377962.

You will also need a replacement 3/8 x 3 inch pin, # LC225598, to connect the foot to your jack if yours is missing.

expert reply by: Jameson C

0

Answer 1

An E1 error code on your Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU #FR93FR means that it tried to ignite twice but didn't have the correct amount of gas pressure. First check to make sure your gas valves are fully…

view full answer...

Answer 2

We do have an option for replacing your Elixir ELX-60. Unfortunately there is not going to be a direct replacement for the converter section. You will need to replace the entire panel with the Progressive Dynamics 4500 Series RV Converter…

view full answer...

Answer 3

The correct set of replacement brake assemblies for your AxleTek 12 inch assemblies is the kit part #AKEBRK-7-SA that you referenced. This kit is a pair of left and right assemblies that are an exact match to what you have that are also self…

view full answer...

Answer 4

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

view full answer...

Answer 5

It looks like the closest we have to those measurements is the Replacement Support Arm Assembly for Solera Pitched RV Awnings LC260294 which measures 66 1/8" long. Just to be clear, you will need to measure the wall mount from the top to the…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 9

That’s a great question Chadwick, and this is one of those situations where the change in technology really matters. The GE Appliances Low-Profile RV AC w/ Heat Pump part #GE26RR will replace your current ARC13AACBL2 setup, but it’s important to know…

view full answer...

Answer 10

Hi Clint! I do have a couple center caps that I think will look nice on this tire/wheel combo, but the Goodyear Endurance ST205/75R14 Radial Tire w/ 14" Eagle Aluminum Wheel - 5 on 4-1/2 - LR D #GY57QB does not have any included with it. So with…

view full answer...

Answer 11

Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…

view full answer...

Replacement Foot Pad for Lippert Ground Control 3.0

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching