How Does a Lend-a-Hand Folding Grab Handle Install
Updated 03/21/2013 | Published 03/20/2013
Question:
The lower section of the grab Handle is loose and needs to be tightened or a back brace needs to be installed. I do now know the technique used remove or tighten the bracket
asked by: Ed L
0
Expert Reply:
The Lend-a-Hand Folding Grab Handle # AM-300 that you referenced installs with 2 screws on each mounting bracket. If you look at the brackets you should see 2 holes that screws will go through and then screw into your trailer.
To remove or tighten these screws you will just need to get a Philips head screw driver and tighten/loosen the screws.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Lend-a-Hand Folding Grab Handle for RVs - Silver Rail with Black Foam Grip - Aluminum
- RV Handrail
- Grab Handles
- Folding
- Aluminum
- Bolt-On
- 24 Inch Long
- Silver
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Will Lend-a-Hand Mini fit existing Winnebago grab handle holes? Mounting pattern and install guide
- Q&A: Looking For Hand Rail Solution For 2020 Grand Design Imagine 2970RL With MORryde Step
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Tips for Installing Replacement Foam Grip with Hardware for Lend-a-Hand Grab Handle
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Q&A: Tripod Stabilizer for Fifth Wheel Pin Box with Andersen Ultimate Connection Adapter
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Q&A: Recommended Replacement Converter W/ Charger For Older 6300A Model 6332
- Article: Trailer Lighting Requirements
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Maintenance Schedule
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps