Can TST TPMS for RVs # TST-507-FT-4 be Used on Rubber Valve Stems

Question

Question:

Can these be used with the stock rubber valve stems ?

asked by: Tony S

0

Expert Reply:

Yes the TST TPMS for RVs # TST-507-FT-4 that you referenced can fit on rubber valve stems of a trailer wheel.

expert reply by: Jameson C

0

Answer 1

To use the TST TPMS 4 Flow Through Tire Sensors item #TST-507-FT-4 or 6 Flow Through Sensors item # TST-507-FT-6-C you will need to swap out your rubber valve stems with valve stems that are steel, chrome or nickel. You can use the Americana Metal,…

view full answer...

Answer 2

Hey Jeff, thanks for reaching out. Aside from the suction cup mount, there is one other mount for 7" WiSight display. Take a look at the Voyager Universal Mount #VOSHD6MNT. This allows for permanent installation on your dash and uses a ball and…

view full answer...

Answer 3

The flow through feature of the TST TPMS for RVs - Grayscale Display - Signal Booster - 4 Flow Through Tire Sensors #TST-507-FT-4 will still work on rubber valve stems, though TST does recommend that metal valve stems are used with these sensors. You…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

They Thomas, I'd be glad to help you pick out which tire pressure monitor system would be better for you. So generally what we have found is that the TST system part #TST-507-RV-4-C is a bit more rugged and will withstand a little more abuse…

view full answer...

Answer 10

Hey Michael, this is a great question but the difference between the TST TPMS part #TST44VR and the part #TST-507-RV-4-C is just the display. The part #TST-507-RV-4-C is a display with buttons along the side of it it to make changes whereas the part…

view full answer...

Answer 11

According to my contact at TST, going with the internal sensor would have the following benefits: • Battery Life. The internal sensors can be expected to last 5+ years, versus about 1 to 1-1/2 years for the external. • Protection: By virtue of the…

view full answer...

Can TST TPMS for RVs # TST-507-FT-4 be Used on Rubber Valve Stems

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching