Trailer Brake Controller Wiring Harness for a 2001 Chevy Suburban 2500

Question

Question:

do you have one for this model?

asked by: Ron T

1

Helpful Expert Reply:

If your 2001 Chevy Suburban 2500 came with a factory installed 7-Way trailer connector then you can use brake controller wiring harness # 3025-P with the P2 controller # 90885. There may be some additional connections you will need to make under the hood to make everything fully functional. I have included a link to an FAQ article that will help.

If your Suburban did not come with the factory 7-Way you will need to add one using # 30955. The connector to plug this 7-Way into is located above the spare tire under the vehicle.

expert reply by: Michael H

1

Answer 1

All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output pin.…

view full answer...

Answer 2

The Dexter part number 023-357-00 is a 12x2 electric brake assembly. The correct RH assembly to use to replace what you have would be the part #23-459 and for the LH assembly you would want the part #23-458 if you have 6K axles. If you have 7k axles…

view full answer...

Answer 3

I have included a couple of pictures that show where to plug in a brake controller on a 2001 Chevy Silverado. You are looking for the black junction box located towards the back left corner on the drivers side. Remove the cover and you will see a…

view full answer...

Answer 4

Hey Peter, so according to the instructions for the Curt Trailer Hitch Receiver #C38BR, Curt recommends you tighten all M12 hardware to 86 ft-lbs.

view full answer...

Answer 5

The Curt TruTrack Weight Distribution System part #C17500 which is rated for up to 10,000 lbs gross trailer weight and 1,000 lbs tongue weight would work but it wouldn't perform as well as the Curt TruTrack Weight Distribution System part #C17499…

view full answer...

Answer 6

I checked and the spring bars of the Curt TruTrack Weight Distribution System #C17500 are 35" long and 1-1/4" wide and based on your photo and the necessary positioning of the brackets. I do have a solution which could work for you,…

view full answer...

Answer 7

I have some good news to offset some of that anger from recently being scammed. We do indeed have all of the replacement parts available for the Curt TruTrack Weight Distribution System #C17500 and I will list them out below. Replacement L-Pins and…

view full answer...

Answer 8

The difference between the Curt TruTrack #C17501 and #C17499 are their weight capacities and the #C17501 comes with a 2-5/16" hitch ball already installed, whereas the #C17499 would require you to purchase one and torque it down yourself. The…

view full answer...

Trailer Brake Controller Wiring Harness for a 2001 Chevy Suburban 2500

Featured Help Information

Miscellaneous Media

Continue Researching