Diagnosing Air Leak At Elbow Fitting On Air Lift LoadLifter 5000

Updated 04/07/2021 | Published 04/05/2021

Products Featured in This Question

Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle

(1944)

$584.99

Air Lift Air Hose Cutter

(105)

$31.42

Question:

Elbow fitting leaks at elbow not hose can’t get a wrench in it to check tightness any suggestions?

asked by: Garry R

Expert Reply:

The elbow fitting is a common place for leaks with air suspension kits such as the Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle # AL57338 that you have. The most common culprit is an air line that is not cut completely flat and clean. I attached a section of the instructions that provide a few simple steps for diagnosing and fixing the leak.

When cutting the line you want to use Air Lift Air Hose Cutter # AL10530 or a similar device which will ensure you have a clean cut. If you need to remove the fitting itself, I recommend using Loctite Thread Sealant 545 # LT37482 for a tight seal. You may need to put the truck up on a lift remove some of the system in order to accurately check the tightness of the fitting. I attached a couple demonstration videos for you.

expert reply by: Andrew N