Availability of 1-1/8 Inch Tall Rear Hanger For 1-3/4 Inch Wide Trailer Leaf Springs
Updated 03/26/2021 | Published 03/24/2021
Products Featured in This Question
Question:
I am looking for a Rear Hanger for 1 3/4 Double Eye Springs, 1.125 tall.
asked by: Linda Y
1
Helpful Expert Reply:
The # 93003-3X rear hanger measures just over 1-1/4 inch in height (measured from the center of the bolt hole to the top of the hanger) at 1-9/32 in height which is absolutely close enough to the 1-1/8 inch height you were looking for that the articulation of the suspension will make up for that miniscule height difference.
expert reply by:
Mike L
1
Product Page this Question was Asked From
Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 3-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Which Leaf Spring Is The Best Replacement For A Bouncy 2019 Grand Design Momentum 351m 7K Axles?
- Q&A: Where Are TRU52FR Leaf Springs Made?
- Q&A: Updated Dexter Disc Brake Pads With Ears For 6,000LB to 8,000LB Dexter Disc Brake Assemblies
- Q&A: Recommended Tool For Cleaning Threads
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Will the Dometic RV Water Heater # DMC33RR Fit in Place of My Suburban SW6DE?
- Q&A: Replacement 6 Leaf Leaf Spring for a Dexter 7,000 lbs Axle
- Q&A: Changing Spring Hangers To Raise Or Lower A Trailer
- Article: How to Fix a Bad Trailer Ground
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: Slipper Spring Trailer Suspension System Review
- Article: Towing a Trailer? Let's Talk About Brake Controllers