Weld On Bracket for Installing Fulton F2 Trailer Jack
Updated 02/23/2021 | Published 02/21/2021
Question:
Hello, I bought an F2 dual wheel jack with a 5 5/8 x 4 5/8 swivel plate with 3 1/2 x 4 1/2 between the bolt holes. I need a welded mounting bracket because the mounting plate on the jack is not wide enough tp fit on my boat Magic Tilt trailer. Do you have other mounting suggestions? Thank you.
asked by: Luis A
0
Expert Reply:
The weld on bracket you are looking for your Fulton F2 jack is the part # F500277. This is the correct size weld on bracket for your trailer jack.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Weld-On Mounting Bracket and Hardware for Fulton Swing-Up Trailer Jacks with 3" x 4" Mount
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Fulton
more information >
Continue Researching
- Search Results: fulton trailer jack
- Q&A: What is the Mounting Bolt Pattern on Fulton 1600-lb F2 Swing-Up Trailer Jack # F1413040134
- Q&A: Replacement Bearings and Brake Assemblies For 1998 Dexter 9000lb Axle
- Q&A: Recommended Mounting Bracket For Fulton F2 Jack
- Q&A: Troubleshooting LED Trailer Lights that Flicker When Vehicle is Off
- Q&A: Which Solar Panel Should I Use to Keep Battery Charged That Runs Trailer Jack
- Q&A: Will Roadmaster Comfort Ride Shock Absorbers Work on Trailer with Flipped Axles
- Q&A: Will Dexter Self-Contained Hydraulic Jack Fit Dump Trailer
- Article: Boat Trailer Guides: Which are the Best?