Thule Roof Rack Components that Fits Leer Camper Shell

Question

Question:

I am looking to get correct parts to fit the factory installed Thule rails on a new 2020 Leer topper. I will need cross bars, podium mounts?, and any fit kits. Can you help?

asked by: Brett W

0

Expert Reply:

The Thule fit kit part # THKIT3101 fits the Leer camper shell roof tracks which would allow you to use the Thule feet part # TH460R. Then you can use bars like the 60 inch # TH711520 for an aero bar or # TH712500 for square.

expert reply by: Jameson C

0

Answer 1

Based on the picture you sent, Thule helped us identify your system. You have a Thule Tracker II tower with a TK1 Fit Kit To replace the parts of your system, you'll need to purchase either one of those, based on what is wrong with your kit. They…

view full answer...

Answer 2

Thank you for the info an the picture! You do have the flush rails on your 2022 Toyota RAV4 so that cutout right next to your hand in the photo will pop up and that's where your roof rack will be anchored to your vehicle. You can reuse your…

view full answer...

Answer 3

You're in a tough spot as Thule has basically phased out your entire roof rack setup from the feet, to the bars, and the fit kit. I wish I had something I could offer that was simple and easy but based on your situation I would go with option 4…

view full answer...

Answer 4

Hey Rod! Thule has phased out your entire roof rack setup from the feet, to the bars, and the fit kit. We do not have any crossbars that attach to your Thule TK series foot bases like item #753-2150. Instead, I recommend using the Rhino-Rack Roof…

view full answer...

Answer 5

I have an answer for you. As far as the replacement parts for the Thule Fit Kit for Thule Podium Style Roof Racks - 3101 #THKIT3101, those components are unfortunately not sold individually. This is because since Thule fit kits are designed for…

view full answer...

Answer 6

Ok Sean, so I was able to track down some info about your LEER camper shell and it looks like you ordered it with the Thule tracks already installed. So, if that's the case, you can then use either the Thule Tracker II feet with the Thule WingBar…

view full answer...

Answer 7

You are correct, you need the Thule Fit Kit #THKIT3101 to connect the Thule Roof Mounted Top Rack System #THTB60 that is on your Leer Work Cap, to the Rapid Podium Feet #TH460R. And then finally your Thule SquareBar Evo Crossbars #TH712500. I highly…

view full answer...

Answer 8

The Replacement Track Nut for Thule #853-2106 uses a M6 x 17mm bolt like the Replacement M6 x 17 mm Bolt #924-0617-15. I have also included a diagram that has additional measurements outlined. The Replacement Track Nut for Thule #853-2106 is a…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Thule Roof Rack Components that Fits Leer Camper Shell

Products Featured in This Question

Continue Researching