No Trailer Turn Signal or Brake Lamp Signal on 7-way Trailer Connector-2004 Nissan Armada
Updated 12/08/2020 | Published 12/05/2020 >
Question:
I have a 2004 Nissan Armada with factory trailer wiring I have all three relays installed2 under hood 1 under dash and I only have running lights no brake or turn signal on trailer
asked by: Chad
Expert Reply:
Since you have the proper relays in place, I'd check the tow package fuses and make sure they're in place and not blown. The online owner's manual I looked at didn't have a fuse diagram, so I'd recommend pulling the cover off the fuse box under the hood and checking out the fuse diagram on the lid to find the fuses for the trailer turn signals and brake lamps. Make sure they're installed and still good. Replace as needed.
Product Page this Question was Asked From
Factory Style 7-Way and 4-Way Flat Vehicle End Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 4 Flat
- 7 Blade
- Plug Only
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Door Latch for 3/4" Thick Door on Featherlite Trailer
- Q&A: Inner and Outer Diameter of the Chrome Edge Trim SAT012ET
- Q&A: Broken Screw in Hole for Trailer Connector Bracket on Blue Ox Base Plate Kit
- Q&A: Recommended Wiring Harness and Relays for a 2025 Nissan Frontier
- Q&A: Hitch and Trailer Wiring Recommendation for 2025 Chevy Equinox Activ
- Q&A: Where is the Brake Controller Adapter Port on a 2019 Nissan Titan
- Q&A: Recommended Trailer Hitch for a 2020 Infiniti QX60
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Lighting Requirements
- Article: Brake Controller Installation: Starting from Scratch
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?


