Square Replacement Taillight Lens With 3-9/16" Hole Spacing
Updated 09/09/2020 | Published 09/06/2020
Question:
Taillights on my trailer resemble Optronics STL-28RB dimensions 5 x 5 1/4, but square lens 4.5 x 4.5 mounting holes are narrower 3 9/16 inches apart.
asked by: J. O
0
Expert Reply:
The Replacement Tail Light Lens for STL2RB and STL3RB part # AL8RB-1G offers hole center to center measurements of 3-3/4". Which would be very close and as close as I am able to come up with to the 3-9/16" you have. Check it again to see what you get as they are only about 3/16" different.
expert reply by:
Randy B
0
Product Page this Question was Asked From
Miro-Flex LED Trailer Tail Light - 7 Function - Submersible - 20 Diodes - Square - Red - Driver
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Marker
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5-1/4L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Is the Bezel Included w/ the Miro-Flex LED Trailer Side Marker?
- Q&A: Looking for Wheel Center Cap AC-375TT
- Q&A: Measuring Bolt Pattern To Determine Which Electric Brake Assembly to Use
- Q&A: Replacement Passenger Side Miro-Flex LED Trailer Light 38 Diode
- Q&A: Replacement Tail Light For 5X10LGW2K Trailer
- Q&A: How to Wire the Red Identification Light Bar with White LED Utility Light OPT88FR?
- Q&A: Wheel Lug Nut Torque Recommendations for 1/2-Inch Stud and 12-Inch Aluminum Wheel
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)