Removing Rivets to Install Curt Spring Bar Retainer Package # 17109
Updated 09/02/2020 | Published 08/31/2020
Question:
Hello, How do I remove this shank of the drive screw? I cant pliers on it...its too round. Any ideas? Thanks.
asked by: Tony K
0
Expert Reply:
You will need a chisel to remove the head of the old rivet and a pin punch to remove the remaining shank so that you can install the part # 17109 that you referenced.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Accessories and Parts
- Weight Distribution Hitch
- Hardware
- Rivets
- Spring Bar
- CURT
more information >
Continue Researching
- Q&A: Recommended Solar Panel Expansion Kit that Works w/ Go Power GP-PV-200M Solar Panels
- Q&A: Replacement Spring Bar Retainers Compatible With Reese 49912 Weight Distribution Hitch
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: How to Remove and Install the Spring Clip for a Fastway e2 WDS
- Q&A: Recommended Weight Distribution System w/a 2-1/2" Shank for a 17,500 lbs Trailer
- Q&A: How to Remove Round Spring Bars Stuck on Head of Fastway e2 Weight Distribution System
- Q&A: Replacing Lippert 3,500 Pound Axle with 76 Inch Spring Seat Length
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Hitch Installation Tips