Dimensions of the Inner Tube and Caster Hole for the Bulldog Trailer Jack # BD195369

Updated 09/21/2012 | Published 09/19/2012

Question:

Please advise outside square dimensions of INNER sleeve. Please advise attachment hole size on inner sleeve so suitable pin can be determined. Maybe an unfair question....? but... Is it possible to purchase this model with a SWIVEL side wind handle where the handle can be swivelledfoot safely out of the way when not in use? I am incorporating this jack on a bespoke engineering project incorporating up to 12 jacks initially. our customer is in the States Any help appreciated. Thankyou

asked by: Greg W

Expert Reply:

I went out and measured a Bulldog Square Jack # BD195369 like you referenced and found that the dimensions of the inner square tube are 1-15/16 inch by 1-15/16 and the hole has a diameter of 9/16 of an inch.

Check out the picture I attached that shows this measurement.

I wish we had an option that would allow the handle to swivel out of the way, but we do not offer anything at this time that would do that.

expert reply by: Jameson C