Video Transcript for Review of the Bulldog Round Jack without mount

Today we're going to take a look at the Bulldog round side wind jack without a mount and a 10 inch lift and a 2000 pound weight capacity. Now, this jack is a nice, durable, heavy gauge construction. The outer and the inner tubes overlap for nice additional strength when the jack's fully extended. They do use a weather-resistant coating on the outer tube and a zinc finish on the inner tube. It does offer a screw nut stop that'll prevent damage to the screw and/or the nut when this jack is fully extended.You notice it does have the side wind handle for a nice, smooth, ergonomic design for easy cranking. And also right up here by the handle, you can see they have a grease Zerk fitting that allow for easy lubrication of the bearings.

It does have long bearing and gear life. It does use an oil impregnated bushing. It is a direct well design. And this jack is ASABE compliant. Again, it is a round jack.Now, this does not come with a hole in the inner tube for mounting a foot plate.

Bracket height on this overall is going to be 17 and one-eighths inches when it's retracted. And when it's fully extended, it'll be 27 and one-eighths inches. So the travel is 10 inches. Lift capacity on this jack is 2000 pounds. Outside tube diameter is two and a quarter inches, and the inside tube diameter is two inches.As you can see, it has a nice ergonomic grip on the side wind handle.

Very easy to crank. To crank that way, you can see it extends out. And if you crank it this way, it'll rotate back.But that should do it for the review on the Bulldog round side wind jack without a mount, a 10 inch lift, and a 2000 pound weight capacity.