How Much Can the Conventional Ramp Door Spring for 6' Wide Enclosed Trailer Be Cut Down
Updated 07/01/2020 | Published 06/29/2020
Question:
what is the smallest length you can cut this down to? my door is only 3.6ft wide.
asked by: Ryder
0
Expert Reply:
The Conventional Ramp Door Spring for 6' Wide Enclosed Trailer part # 362SA6 can be cut down to fit a 38" wide doorway. Therefore, it would indeed work with a roughly 3-1/2' wide doorway.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Conventional Ramp Door Spring for 6' Wide Enclosed Trailer - Single Spring - 120-lb Capacity
- Trailer Ramp Springs
- Single Ramp Spring
- Torsion Spring
- 150 Inch Cable
- 86 - 120 lbs
- Conventional Spring
- 4 Foot Wide Trailer
- 5 Foot Wide Trailer
- 6 Foot Wide Trailer
- 69 Inch Wide Spring
- TRC
more information >
Continue Researching
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Q&A: Pictures for Showing How Trailer Ramp Springs Attach to Enclosed Trailers
- Q&A: Recommended Garage Door Spring for a 5' Wide Trailer Door
- Q&A: Ramp Door Spring Recommendation for a 2009 Carson 6x10 Enclosed Trailer
- Q&A: Availability of Replacement Grease Seal 450133
- Q&A: Replacement Hub/Rotor Assembly for a Dexter Boat Trailer Axle DX67HR
- Q&A: Troubleshooting Weak Braking After Installing New Dexter Electric Brakes on Trailer
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Wiring Diagrams
- Article: How to Install E-Track in 3 Easy Steps
- Article: Best Bike Racks for Electric Bikes
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Ram Trailer Tow Prep Package
- Article: Brake Controller Installation: Starting from Scratch