How To Measure and Replace Oval Flush Mount Trailer Lights
Updated 06/29/2020 | Published 06/26/2020 >
Products Featured in This Question
Question:
how to measure oval flush mount trailer lights for replacement LED lights
asked by: Lennis L
0
Expert Reply:
Great question! For oval trailer lights you want to measure the lens width and length from edge to edge. For example, Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 10 Diodes - Red Lens Item # STL72RB. The most common flush mount trailer lights are 6 1/2" x 2"
I also recommend PVC Grommet for 6-1/2" Oval Trailer Tail Lights Item # a70gb
I added a video link to help walk you through the instillation
expert reply by:
Shane H
0
Product Page this Question was Asked From
Optronics LED Trailer Light - Brake, Tail, Turn - Submersible - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: How is Horse Trailer Side Pad # HTP60BK Usually Attached
- Q&A: Recommended Class IV Hitch for a 2012 Chevrolet Silverado 1500
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting Error Codes SH and OL on a Tekonsha Prodigy Brake Controller
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended AC System to Replace Two Dometic Duo-Therm AC Units Controlled by the Same Thermostat
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)


