Thermostat Wiring Diagram for Advent AC Unit part # ACM135B

Question

Question:

The 12vdc for the thermostat is supplied by the main unit. So there is no need to run a12vdc line to the main unit. Correct? In other words, the only power wires I need to run for an entire new install is the 120VAC line? Please confirm this as I’m getting ready to put the roof on this RV rebuild and I have to run all necessary wiring now before closing the roof. Thanks

asked by: Jay C

0

Expert Reply:

I attached a diagram for the thermostat wiring of the Advent AC Unit part # ACM135B for you to check out.

expert reply by: Jameson C

0

click to enlarge

Jay C.

6/18/2020

The 12vdc for the thermostat is supplied by the main unit. So there is no need to run a12vdc line to the main unit. Correct? In other words, the only power wires I need to run for an entire new install is the 120VAC line? Please confirm this as I’m getting ready to put the roof on this RV rebuild and I have to run all necessary wiring now before closing the roof. Thanks

Reply

Jameson C.

6/18/2020

This is correct. The 12 volt DC input for the thermostat comes from the main AC unit and does not need to be ran separately.

Reply

Answer 1

Advent Air Conditioners like part #ACM135 come with a connector that pairs up directly with the standard 6-wire connector. If you have a 9-wire connector then you need the kit #ACRG15 as well. For wiring I'm attaching some photos of diagrams for…

view full answer...

Answer 2

There is not a standard plug available that would allow you to plug the Advent Air Rooftop RV Air Conditioner #ACM135 right to an extension cord. The unit will need to be hardwired using the included wiring and hardware. I have attached the complete…

view full answer...

Answer 3

For replacing the Dometic Duo Therm that you have now you would want the Advent Air part #ACDOM135B which is also a 13.5k BTU unit. Since what you have now has a heat pump you'd also want the heat strip part #ACMHD and you'd be set. This will…

view full answer...

Answer 4

If you have the ACTH12 then you should also have the Air Distribution Box #ACRG15 which will have a control box for your wiring from the rooftop unit #ACM135 and the thermostat. This air distribution box and thermostat will wire up exactly the same…

view full answer...

Answer 5

The Digital Thermostat ACTH12 is a confusing thermostat since it can be used with heat pumps, heat strips and furnaces. First you will want to make sure you have the dip switches on the back of the controller set up correctly. If you are just using…

view full answer...

Answer 6

I can confirm that the Advent Air RV Air Conditioner item #ACM150 is designed to replace Dometic ac units like your 57915.341 model. I have linked an installation video below so you can see the process to get this unit installed. It is also available…

view full answer...

Answer 7

Hey Nathan, the Advent Air Dometic AC replacement part #ACDOM150 is exactly what you are looking for to replace what you have now and it will give you a super easy install that uses the same connectors and brackets so it would be about as painless as…

view full answer...

Answer 8

The MaxxAir Replacement RV Air Conditioner Cover - Coleman-Mach / RVP Brand RV Air Conditioners - White #MA8335A5261 is the replacement I recommend for you and it has a simple installation. It will fit your Coleman AC unit.

view full answer...

Answer 9

In order to replace your Carrier Air V RV Air Conditioner I highly recommend using the Advent Air Replacement RV Air Conditioner for Carrier Setup part #ACCAR135 for 13,500 Btu's or part #ACCAR150 for 15,000 Btu's. This unit will be the only…

view full answer...

Answer 10

If your thermostat has a heat setting it's typically for the heat pump, but you can quickly tell by looking at the connector of of the rooftop unit to the zone controller. If it's a 6-pin then it doesn't have a heat pump, but if it's…

view full answer...

Answer 11

The Advent 135 #ACM135 that you have is designed to replace a Coleman AC unit that uses a thermostat. You can wire up the unit with the heat strip part #ACMHD to the thermostat you currently have if you want. I attached a diagram that shows how it…

view full answer...

Answer 12

Typically if there are two wires running from the furnace to the AC system then it means that the furnace has power already connected to it and it sends that through one of the wires up to the AC until the system calls for heat, at which point the…

view full answer...

Thermostat Wiring Diagram for Advent AC Unit part # ACM135B

Product Page this Question was Asked From

Continue Researching