Parts Needed To Install Disc Brakes On a 2010 Sea Doo Challenger 180 Trailer
Updated 06/05/2020 | Published 06/03/2020
Products Featured in This Question
Question:
Hello, Im looking for a marine disc brake setup for my 2010 Seadoo Challenger 180 single axle boat trailer. Boat weights 2000 pounds. I dont have any brakes on the trailer at this time, but it does have the 4 bolt mounting plate for brakes. Can you recommend a complete package for disc, actuators, lines.... It is being pulled by an F-150 with onboard trailer brake controller. Thanks!
asked by: Jeremy C
Expert Reply:
In order to choose the correct disc brakes for a 2010 Sea Doo Challenger 180 Trailer you'll need to know the axle capacity. If you have a 2,000-2,200 lb axle you can use the Kodiak Disc Brake Kit part # K2HR2D but if you have a 3,500 lb axle then you can use the Kodiak Disc Brake Kit part # K2HR35D.
In order to complete your setup you'll need the HydraStar Marine Electric Over Hydraulic Actuator Kit part # HS381-9067 and Kodiak Hydraulic Brake Line Kit part # 18SI-BLKIT.
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 8" Rotor/Hub - 5 on 4-1/2 - Dacromet - 2,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 2000 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Brakes, Hub and Drum Assembly with L44649 Inner and Outer Bearings on 2000lbs Axle
- Article: Trailer Lighting Requirements
- Q&A: Adding Electric Brakes To 2,200lb Dexter Torsion Axles
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Installing 7-Way Trailer Connector on 2005 Ford E-150 Van
- Q&A: Troubleshooting Trailer Lights Remaining On After 2020 Chevrolet Silverado 1500 is Shut Off
- Q&A: Is There a Brake System For a 3,500LB Axle Which Will Allow For 10 Wheels?
- Q&A: Which Lug Nuts To Use on 17.5" Trailer Wheels