What Is the Torque Spec for the Replacement Wheel Stud, Screw-In 25-53
Updated 06/04/2020 | Published 06/03/2020
Products Featured in This Question
Question:
Got a set of these and was wondering what the torque spec was
asked by: Kevin B
0
Expert Reply:
I don't have an exact torque value for the Replacement Wheel Stud, Screw-In part # 25-53 but I recommend using the same amount of torque you would use for the lug nuts. This will vary by wheel size and construction but i'd say around 90-100 ft. lbs. Please note you'll also need to use the Loctite Blue Stick Threadlocker part # LT37643.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Replacement Wheel Stud, Screw-In, 1/2" x 2"
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Screw-In Stud
- 2 Inch Long
- Redline
more information >
Continue Researching
- Q&A: Which Stainless Steel Lug Nuts to Use with Aluminum AM03 Series Gunmetal Trailer Wheel
- Q&A: How to Identify What Lug Nut Pattern a 5 Lug Wheel Has
- Q&A: How Old Are Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire
- Q&A: Looking for Wheel and Tire with Bolt Pattern 5 on 4-3/4 inch
- Q&A: Can Studs be Installed and Used Instead of Bolts for Trailer Hubs/Wheels
- Q&A: Bushings To Replace Lippert Never Fail Bushings
- Q&A: Replacement Hub With LM48548 Inner Bearing And L44649 Outer Bearing
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Trailer Lighting Requirements