Brake Controller and Wiring Installation on 2018 Cherokee Trailhawk With Factory Tow Package

Published 05/01/2020

Products Featured in This Question

Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In

(79)

$14.95

Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers

(164)

$57.18

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3477)

$118.67

Question:

I failed to verify that our Cherokee had the plug under the dash before I asked for assistance. I’m having no luck locating the connection for the product I asked about. I think I need a different connection.

asked by: David H

Expert Reply:

The Tekonsha Primus IQ Trailer Brake Controller # TK90160 you referenced will require custom wiring harness # 3014-P for your 2018 Cherokee Trailhawk w/factory tow package. It will be plug and play using that harness. I've attached a video of the similar installation to assist.

expert reply by: Jason S

click to enlarge

David

5/1/2020

Jason S.

5/1/2020

If you have the factory 7-way it is likely you have the under dash connection for a brake controller. I've attached a photo of the location. The connector is behind the black cover located to the left of the steering column, just above the carpet. It will have a cover that will need to be removed. I've attached a photo to assist. If you didn't have the factory 7-way then you would need to add a wire for your brake controller for both power from the battery and for the brake controller output to the 7-way. If you have a 7-way but don't have the connection under your dash then you will need to use # 5506 for your brake controller wiring to a 7-way. If you don't have a 7-way, then use # ETBC7 instead.