Are Bulbs Included with the Double Bullseye Trailer Clearance, Side Marker Light

Question

Question:

Does the mc42ab marker light include the two light bulbs? Or must those be purchased separately?

asked by: Fred B

1

Helpful Expert Reply:

The 2 bulbs are included with the Double Bullseye Trailer Clearance, Side Marker Light # MC42AB so you don't have to worry about grabbing some of those to use this light.

Attached is an installation video that you can check out.

expert reply by: Jon G

1

Answer 1

With our experiences installing and using the various electric over hydraulic actuators out there the consensus is that the Hydrastar actuators have the quickest response time and are the most reliable. All of our installers when asked will say that…

view full answer...

Answer 2

It sounds like you are asking what wire should be ground and which is power for installation of the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459. The wires can be used for either, so if you want to use the black for ground you can, and…

view full answer...

Answer 3

Hey Steve, yes the MaxxFan Dome Roof Vent w/ 12V Fan #MA00-03812B that you referenced does include the rain guard that allows it to side mount without allowing water in. It is in the bottom right part of the picture I attached.

view full answer...

Answer 4

No problem. If your existing trailer interior lights use a 1-wire hookup this means they use their mounting hardware to make the ground connection and the single lead is the +12V feed. Adding more high-efficiency LED lights with 2 wires will only…

view full answer...

Answer 5

To replace your 12" brakes I recommend checking out the 7K TruRyde Electric Trailer Brake Kit #TRU96FR or the 5.2K - 7K Hydraulic Trailer Brake Kit #AKUBRK-7 depending on what kind of braking system you have. You'll also need the Mounting…

view full answer...

Answer 6

We may have a replacement hub for your Dayton Fayette 9254, but the only way to be sure is by determining which bearing combination and grease seal your spindle uses. You will need to remove one of the hubs and look for the bearing numbers stamped in…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The width (or diameter) of the ring portion itself is 1-1/2 inches for both the Buyers Products 2-1/2" I.D. Lunette Ring #337BDB12503 and the Curt Lunette Ring #C48520.

view full answer...

Answer 9

The Curt stud mounted lunette ring #C48520 has an M39x2-6H stud bolt size. The stud length is 3-3/8 inches. And the inner diameter of the ring is 2-1/2 inches.

view full answer...

Are Bulbs Included with the Double Bullseye Trailer Clearance, Side Marker Light

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching