Recommended Brake Controller Wiring Harness for 2018 THOR ACE
Updated 04/21/2020 | Published 04/19/2020
Products Featured in This Question
Question:
Hello. I have a reese brakeman iv brake control that I want to install in my 2018 Thor Ace. I need a wire harness and cant find the one that I need. Please advise. Thank you.
asked by: John M
Expert Reply:
For your 2018 THOR ACE you will simply need the wiring harness # 3035-P. This harness will connect under the dash to your factory wiring near the OBD II and will directly plug into your Reese Brakeman IV Controller. I've attached a video to assist.
It appears the brake controller wiring may not be fully run to the rear of your motorhome, so if you don't already have the 7-way you will need to complete your wiring using the # ETBC7 kit.
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: go power solar panel
- Search Results: go power overlander
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: How to Convert a Surge Brake Coupler to an Electric Over Hydraulic Braking System
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What Safe-T-Plus Steering Stabilizer will Work on My 2014 F-53 Chassis 18,000?
- Q&A: What Is The Difference Between Safe-T-Plus Steering Stabilizer ST28MR And ST88MR?
- Q&A: Can Stand Alone Single Acting Hydraulic Pump Be Used For Stillwell Hydraulic Trailer Jack?
- Q&A: Where Is Brake Controller Install Port for 2003 Ford F-150
Jason S.
4/21/2020
For your 2018 THOR ACE you will simply need the wiring harness # 3035-P. This harness will connect under the dash to your factory wiring near the OBD II and will directly plug into your Reese Brakeman IV Controller. I've attached a video to assist. It appears the brake controller wiring may not be fully run to the rear of your motorhome, so if you don't already have the 7-way you will need to complete your wiring using the # ETBC7 kit.