Recessed Floor Storage Box Compatible with Toyhauler Trailer

Question

Question:

In floor storage box!!! Will it fit in all toyhauler?

asked by: Francis S

0

Expert Reply:

The locking storage box # M387FR mounts in the floor. As long as you have the 19" wide x 29" long x 7-1/4" deep space, it can absolutely work in a toyhauler. The box recesses into the floor and is powder coated for protection against corrosion and rust. I've attached a photo to assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

Yes, both the 2 inch hub, #ERT034, and the 2-1/2 inch hub, #ERT057, attach to the same side arms, #ERT039 and #ERT040, and use the same clamp bolts, #ERT052. So the 2 inch hub will work with the same parts currently on your 2-1/2 inch system!

view full answer...

Answer 2

If you have an ISR Series PullRite SuperGlide 5th Wheel Hitch which is the 2300, 2700, and 2900, models then you can use the Reese Quick-Install Custom Installation Kit part #RP50066-58 which is a custom fit kit so no drilling is required.…

view full answer...

Answer 3

The U-Bolts used on the Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88338 will allow you to install the B&W Turnoverball Underbed Gooseneck Trailer Hitch #BWGNRK1012 on your 2015 Chevrolet Silverado 2500. The U-bolts are wide enough…

view full answer...

Answer 4

Hi Scott; the Bulldog Cast Head Coupler w/ Wedge Latch #BDA200C0317 does not have the same functionality as the eZ-Latch. If you want an adjustable channel mount coupler that lets you hook up when the latch is in the closed position you can use the…

view full answer...

Answer 5

The Repair Kit Fulton Wedge-Latch Cast Head Coupler, #F670801, is designed to fit the coupler #BD44125W0317 which does take a 2-5/16 inch ball.

view full answer...

Answer 6

Yes, it is! The RV Flooring Adhesive for Vinyl Over Wood, Metal, or Concrete item #TS58FR is freeze-thaw stable to 15° F and would have to be heated up to at least 212° F once it has dried and cured. What kind of trailer do you have?

view full answer...

Answer 7

Bright Way actually has a replacement plunger for their Breakaway kit par #3802311 that you have with the part #3802350 which does happen to look very similar too the Fastway replacement plunger part #FA80-01-2206.

view full answer...

Answer 8

The Pollak switch part #PK34513 that you referenced would be a great option, but I'd rather recommend you go with the Buyers Products Toggle Switch with 2 Blade Terminals - Recessed Panel Mount #337SW911 as this setup was made for your exact…

view full answer...

Answer 9

If your electrical distribution system is not rated for 30 amps you should not be trying to plug into a 30 amp RV power pedestal at a camp site. From the attached images you are correct, you obviously have a 20 amp plug as it is clearly labeled for…

view full answer...

Answer 10

The Tekonsha Push-to-Test Trailer Breakaway Kit #50-85-313 that you referenced includes the small 12V rechargeable battery and charge wires that will be connected to the 12V circuit on the trailer's 7-Way. You could physically use the system with…

view full answer...

Answer 11

The signal booster included with the Tireminder #TM29FR does not necessarily need to be connected directly to a battery. As long as the black wire is grounded and the red is connected to constant 12v, it is all means to the same end. The booster…

view full answer...

Answer 12

When using the TireMinder i10 TPMS for RVs #TM29FR, it is recommended to not use valve extenders. Obviously this is not always possible. But the manufacturer does state that if you do need extenders, you should use straight extenders that are steel…

view full answer...

Recessed Floor Storage Box Compatible with Toyhauler Trailer

Product Page this Question was Asked From

Continue Researching