Parts Needed To Install MaxxAir MaxxFan Plus Roof Vent As New Install

Question

Question:

I bought this as a new install not a replacement, so I have no way to operate it. If I buy the MA00A03550K controller, will it operate the unit I bought? How does it operate it, via battery? My install is for camping with limited power, so I want to make sure it will work. The instructions I was linked to by your customer service rep does not have my model listed on any of the nine pages that speak about controllers and remotes. Thank you,

asked by: Linda G

0

Expert Reply:

The MaxxAir MaxxFan Plus Roof Vent part # MA00-04751KSX is designed to replace an existing roof vent fan. Therefore, it does not come with everything needed for installation. The extra items you will need are as follows:

Key Wall Control part # MA00A03550K
Ceiling Garnish part # MA54FR
RJ11 Communication Cable part # 34279523
Roof Vent Installation Kit part # 344270KITW

expert reply by: Conner L

0

Rene C.

12/26/2025

THIS A NEW INSTALLATION ,CAN'T USE A WALL SWITCH. CAN A WIRELESS REMOTE CONTROL WORK WITH THE 4751KS.?

Jerred H.

12/28/2025

@ReneC No, it can not. For a remote controlled roof vent you'll need the MaxxFan Plus Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift item # MA00-04500K.

Answer 1

Hi James, I'm really sorry to tell you, but the MaxxFan Plus part #MA00-04751KSX will not work with a wireless remote. The MaxxFan Plus part #MA00-04751KSX is a direct replacement for the MaxxFan Plus original model 00-04751KS and is intended to…

view full answer...

Answer 2

Hi Steve; does your wall switch look like the #MA00A03550K? The Replacement MaxxFan Plus 4-Speed Roof Vent #MA00-04751KSX is designed to replace the 00-04751KS which works with this wired wall controller. If you have this switch, or the older model…

view full answer...

Answer 3

Hello again Thomas! The #MA00-04751KSX does indeed need to be a wired to a wall control for it to work. It's really used as a replacement or upgrade to a pre-existing damaged or worn out unit. I believe what you are looking for is the MaxxFan…

view full answer...

Answer 4

Hey Jay! The MaxxFan Plus 4-Speed Roof Vent #MA00-04751KSX does not come with a wall controller but it is compatible with one. You will have to pick up the Replacement Key Wall Control For MaxxFan Plus and Deluxe #MA00A03550K separately.

view full answer...

Answer 5

No, I do not Ralph. What model Maxxair vent fan do you have and what part are you needing to replace? You can add this information and any other questions you have where it says Reply to Jerred H and I'll be happy to answer them.

view full answer...

Answer 6

Hey Devon, does your RV roof vent wall control unit look like the #MA59FR? If so you have a MaxxFan Plus RV roof vent that was designed for wall control and for a replacement unit you would want the part #MA00-04500K to use a setup that would use…

view full answer...

Answer 7

Hi Debbie! As long as the RV Safe RV Propane Gas Detector - 12 Volt - 2 Wire - White #RS64FR is no more than 18 inches off the ground, you can mount it however you like! The orientation will make no difference with its performance. What kind of…

view full answer...

Answer 8

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 9

The Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is meant to be a direct replacement however not all the necessary hardware is included. The remaining items you'll need is the Key Wall Control part #MA00A03550K,…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Parts Needed To Install MaxxAir MaxxFan Plus Roof Vent As New Install

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching