Do I Need a Deep Socket to Install the Roadmaster Quiet Hitch
Updated 03/24/2020 | Published 03/23/2020
Question:
what size socket do you need to tighten the nuts and does a short socket work or do you need a deep socket?
asked by: Mike
0
Expert Reply:
The hex nuts on the Roadmaster Quiet Hitch # RM-061 are 9/16" and while a short socket can do the job, a deep socket will likely be the best solution if available. If you can't get the regular socket to work on the bottom hex nut a crescent wrench will also work.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Roadmaster Quiet Hitch for 2" Trailer Hitches
- Hitch Anti-Rattle
- Non-Locking Anti-Rattle
- Universal
- Fits 2 Inch Hitch
- Clamp Style
- Accessory Anti-Rattle
- Towing Anti-Rattle
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is There Lock that Comes with etrailer Spare Tire Mount for Hitch # e98ZR
- Q&A: How Can I Get Better Rock Protection From My Rock Tamers?
- Q&A: Anti-Rattle Device For Weight Distribution System
- Q&A: What Firestone Air Bag Kit and Spacer do I Need for My 2022 F-350 with the Tremor Package?
- Article: Hitch Anti-Rattle Devices: The Ultimate Guide
- Q&A: Can I Tow a 7,000 lb Horse Trailer With the Roadmaster Dual Receiver Hitch Adapter?
- Q&A: What MCD Innovations Shade Motor do I Need to Replace My Motor with mcd.sc.28-12v.1?
- Q&A: Roof Rack and Canoe Carrier Recommendation for 91 lb Old Town Discovery for 2010 Honda Pilot
- Article: How to Choose a High-Low Adapter
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Anti-Rattle Devices