Yakima Rail Grab Brass Nut Screw Size and Replacement

Question

Question:

Hello, what size is the screw that threads into the brass nut on the upper claw base?

asked by: Zach D

0

Expert Reply:

We have the replacement screw you are looking for with the part # Y8880150 which matches up to the nut of the # Y8880279 which is M6.

expert reply by: Jameson C

0

Answer 1

It sounds like you are describing the screw that comes with the Replacement Wedge Assembly #Y8880150. The screw only comes with this kit. The only other possibility is #Y8880148 which are the adjustment knobs for RailGrab towers.

view full answer...

Answer 2

I checked with Yakima and found a chart that will help you determine which size claw you'll need to use with your Yakima Railgrabs. The top three use the small claw #Y80145, the middle two use the medium claw #Y8880205, and the bottom two use the…

view full answer...

Answer 3

For replacement bases for the Railgrab you would want the part #Y8880279. This also comes with a new brass nut.

view full answer...

Answer 4

The discontinued Y8880205 does not include the bolt but the #Y8880150 which is the matching wedge assembly does include it.

view full answer...

Answer 5

The Yakima RailGrabs, which replaced the LowRider line of towers, and is now itself discontinued, did not have any changes to the hardware over its life span so #Y8880279 will fit your RailGrab towers. If you need the wedge assembly it is #Y8880150.…

view full answer...

Answer 6

The replacement screw you are looking for is available in the Replacement Wedge Assembly for Yakima RailGrab Roof Rack Towers #Y8880150.

view full answer...

Answer 7

If you don't have the Replacement Adjustment Knobs #Y8880148 then you will need them to attach the Replacement Large Claw Assembly #Y80144. The knob is what allows you to attach the claw assembly to the Upper Claw Base #Y8880279 on your RailGrab…

view full answer...

Answer 8

While the Yakima Railgrab roof racks are being phased out and not what Yakima currently recommends for your 2016 Mazda CX-5 I was able to determine that they were the correct fit for your 2016 Mazda CX-5 with raised rails. The replacement kit that…

view full answer...

Answer 9

The long, black screw you referred to is not available as a replacement part. The only screw that is would be the silver one you mentioned which comes with the Replacement Wedge Assembly for Yakima RailGrab Roof Rack Towers #Y8880150.

view full answer...

Answer 10

Sounds like you are looking for the Yakima Railgrab Wedge Assembly and Bolt part #Y8880150 which comes with the Allen bolt you are looking for.

view full answer...

Answer 11

It sounds like you are looking for the Replacement Adjustment Knobs for Railgrab part #Y8880148.

view full answer...

Answer 12

We do carry replacement parts for the Yakima Railgrab foot. For the claw base and nut you would want the part #Y8880279. The medium claws are no longer available. For the claws with pin adapters you would want the part #Y8880201. For replacement…

view full answer...

Yakima Rail Grab Brass Nut Screw Size and Replacement

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching