How do Lippert Components 5th Wheel RV Landing Gear Foot Pads Install
Updated 01/27/2020 | Published 01/26/2020
Question:
Foot pad installation. Does the o rings go on the top of the plate or on the bottom by the bolt head
asked by: Chris
0
Expert Reply:
The Lippert Components 5th Wheel RV Landing Gear Foot Pad # LC314667 you referenced will just use your existing foot pad's pin to install. Please keep in mind your current foot pad would need to attach with a 7/16" bolt in order for this Lippert pad to work. I'm not 100% sure what you are referring to in regards to o-rings, however.
I have added a link to a video review of the Foot Pad # LC314667 for you to check out as well.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Lippert 5th Wheel RV Landing Gear Foot Pad - 9" Round
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Utopia Pop-Up Drain Fit a Smaller Sink Opening?
- Q&A: 90 Degree Angled SmartPlug Connector For Inlet
- Q&A: Recommended Landing Gear Foot Plate for 9 Inch Round Upgrade on 2016 Flagstaff Super Lite 5th Wheel
- Q&A: Bike Rack Recommendation for NuCamp 320 Camper
- Q&A: Troubleshooting Flashing Error Code 5.H on Tekonsha Prodigy Brake Controller
- Q&A: What's the RV Designer Motorhome Entrance Door Lock w/ Deadbolt RD68SR Made of?
- Q&A: Solution for Replacement Foot Plate for Lippert Level Up System
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Best Air Bag Suspension 2025
- Article: 5 Products You Need For Your Next Camping Trip (2022)
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?